MEM-8852 MOUNTING INSTRUCTIONS
TOOLS REQUIRED: 3/16” ALLEN WRENCH (PROVIDED)
7/16”
(OR 7MM) ALLEN WRENCH
1. Loosely install the two mounting plates on the windshield, using the
bottom and third bolt up. Leave the nylon washers off. The small tab goes at
the bottom, big one at the top. (See Figure 1-for reference only, Valkyrie plate is not shown)
Install Note: *(Wide) – Tabs point, in towards each
other when installed correctly.
2. Install the four fork clamps, approximately 2 inches apart. Tighten
them, and then loosen them. (See Figure 2)
3. Loosen the four bolts that are to hold the windshield to the fork
clamps, and slide the mounting plates onto the forks. (See Figure 3)
4. Adjust the height, angle, and alignment of the shield and tighten down
the bolts that hold the windshield to the plates, then the bolts that hold the
plates to the fork clamps, then the clamps themselves.
WARNING: This
is a quick disconnect kit. Always tighten down all mounting bolts after
removing or installing the
windshield, every time.
Fig. 1 Mounting plate to w/s Fig. 2 Fork clamps Fig. 3 Valkyrie plate to forks
Care and Cleaning Instructions
To clean your
windshield, use only warm water and a mild non-abrasive, dishwashing liquid.
Use a soft cloth, such as a T-shirt or flannel cloth. To protect your windshield,
please use Novus #2 to remove minor
scratches, or use a polish like Memphis Shades Shinola which is specially designed for plastic
windshields; glass cleansing agents will cause severe damage to
your windshield and will void your warranty.
Never use any glass products, petroleum based
chemicals, or cleaning agents with ammonia, bleach or any harsh chemicals. This
includes Rain-X, brake fluid, acetone, and gasoline.
MEM-8852 MOUNING KIT
|
PART # |
DESCRIPTION |
QTY. |
|
M8852 |
MOUNTING INSTRUCTIONS/PARTS LIST |
1 |
|
M1053 |
LEFT MOUNTING PLATE - WIDE |
1 |
|
M1054 |
RIGHT MOUNTING PLATE - WIDE |
1 |
FOR MISSING OR REPLACEMENT PARTS OR WARRANTY
INFORMATION CONTACT:
Memphis
P.O. BOX 24
COLLIERVILLE , TN 38017
(901) 853-0293