MEM-9823
MOUNTING
PLATES
FOR H-D COVERED
1.
Install the windshield onto the mounting plates using the pre-assembled
bolts on the mounting plates. The santoprene grommet should
be inserted through the holes in the windshield so that the flat round part of
the rubber grommet lays flat on both sides of the windshield. On each plate,
get both tabs started before you tighten them both. (see Figure 1.1 & 1.2)
Note: Tabs
should point in towards the headlight when installed correctly.
2.
Loosen the four mounting bolts for the Fats/Slims windshield, then
remove the windshield and set it aside.
3.
Mount the sportshield like the Fats/Slims,
and tighten down all the mounting bolts. (see
Figure 2)
Warning: Never ride with any part of the hardware
missing or loose.

To clean
your windshield, wash it with warm water and a mild, non-abrasive, dishwashing
liquid. Use a soft cloth such as a
T-shirt or flannel cloth.
To protect your windshield, use
NOVUS #2 to remove minor scratches, or use polish specially designed for
plastic. NEVER use glass cleansing agents, they may
cause severe damage to your windshield.
Never use any petroleum-based
chemicals, or cleaning agents with ammonia.
This includes Rain-X, brake
fluid, acetone and gasoline.
MEM-9823 MOUNTING
SPORTSHIELD FOR
SOFTAIL SPRINGER WITHOUT PASSING LAMPS
Part #
|
Description
|
Quantity
|
|
M823 |
Instruction Sheet/Parts
List |
1 |
|
M501 |
Beveled Socket Washers |
4 |
|
M302 |
1/4’-20 x 1/2’SS Socket
Head Cap Screw |
4 |
|
M713 |
Left Springer Sportshield
Mounting Plate |
1 |
|
M714 |
Right Springer Sportshield
Mounting Plate |
1 |
|
M504 |
Socket
Shoulder Washer |
4 |
|
M505 |
Button Nut |
4 |
|
M543 |
Santoprene Grommet |
4 |
FOR MISSING OR REPLACEMENT PARTS OR WARRANTY
INFORMATION CONTACT:
Visit us on the web at:
customerservice@memphisshades.com