MEM-9836

H-D V-ROD SPORTSHIELD

MOUNTING PLATES INSTRUCTIONS

 

 

TOOLS REQUIRED:  3/16” Allen Wrench                                      

 

ALWAYS COVER THE FRONT FENDER AND GAS TANK TO PREVENT ANY POSSIBLE DAMAGE

 

1.    Install the mounting plates on the windshield using the bolts that are pre-assembled on the mounting plates. Use     

       neoprene washers on both sides of the windshield. On each plate, get both tabs started before you tighten them.                                                                                                                                                                                        

       (See Figure 1.1 & 1.2)

 

                        Note:     *(Wide) - Tabs point towards each other when installed correctly.

                                         

2.   Loosen the four bolts that are to hold the mounting plates to the fork clamps and remove the already installed Memphis Fats or Slims.  Slide the new sportshield hardware onto the fork clamps. (See figure 2)

 

 

3.       Adjust the height, angle, and alignment of the shield. Carefully check gas tank clearance, and tighten all mounting bolts.

 

4.    Place the non-used windshield in a safe storage area. Preferably in a Memphis Shades windshield storage bag.

       Storage bag for Fats/Slims part #MEM0980, Storage bag for Sportshields part #MEM0985.

 

 

                   WARNING:  This is a quick disconnect kit.  Always tighten down all mounting bolts after removing

                   or installing the windshield every time                                                               

                                                                                               

Fig. 1.1   Left side plate            Fig. 1.2 Right side plate                  Fig.2 Shows mounting of plates                                                                                                                              

  

Care and Cleaning

 

Never use any Petroleum based chemicals, or cleaning agents with ammonia.

To clean your windshield, use only warm water and a mild, non-abrasive, dishwashing liquid. Use a soft cloth such as a

Cotton T-shirt or flannel cloth.  To protect your windshield use NOVUS #2 to remove minor scratches, or Memphis Shades

Shinola* polish specially designed for plastic, glass cleansing agents will cause severe damage to your windshield, never

use any glass product. This includes Rain-X, brake fluid, acetone, and gasoline.

 

 

 

MEM9836

PARTS LIST

V-ROD SPORTSHIELD HARDWARE KIT

 

PART #

DESCRIPTION

QTY.

M836

MOUNTING INSTRUCTIONS/PARTS LIST

1

M302

¼” – 20 X ½” SS SOCKET HEAD CAP SCREW

4

M505

BUTTON NUT

4

M504

SOCKET SHOULDER WASHER

4

M543

SANTOPRENE GROMMET

4

M1023

LEFT MOUNTING PLATE - WIDE

1

M1024

RIGHT MOUNTING PLATE - WIDE

1

 

FOR MISSING OR REPLACEMENT PARTS OR WARRANTY

INFORMATION CONTACT:

 

MEMPHIS SHADES

PO BOX 24

COLLIERVILLE, TN 38017

(901)-853-0293

 

 

visit us on the web at

www.memphisshades.com  

 

 

CUSTOMER SERVICE

CUSTOMERSERVICE@MEMPHISSHADES.COM