MEM 9858

SPORTSHIELD MOUNTING KIT FOR H/W VICTORY

INSTRUCTIONS / PARTS LIST

 

TOOLS REQUIRED:  3/16” Allen wrench (provided)

 

1.                  Install the mounting plates onto the windshield using the pre-assembled bolts on the mounting plates. The rubber grommet should be inserted through the holes in the windshield so that the flat round part of the washer lays flat on each side of the windshield. On each plate, get both tabs started before you tighten them. (see Figure 1.1 & 1.2)

 

                Note:    *(Wide)  – Tabs point in towards each other.

 

2.                  Loosely install the four fork clamps 1-3/4” inches apart. (see Figure 2)

 

3.                  Loosen the four mounting bolts that are to hold the mounting plates to the fork clamps, and slide the mounting plates onto the fork clamps. (see Figure 3)

 

4.                  Adjust the height, angle, and alignment of the shield. Carefully check clearance from steering stop to stop, and tighten all mounting bolts.

 

WARNING:   This is a quick disconnect kit. Always tighten down all mounting bolts after removing or installing the windshield every time.

 

   Fig. 1.1  Left side plate     Fig. 1.2 Right side plate    Fig. 2 fork clamps                            Fig. 3  Plate mounting

1-3/4"                  

 

Care and Cleaning Instructions

 

To clean your windshield, use only warm water and a mild non-abrasive, dishwashing liquid. Use a soft cloth, such as a T-shirt or flannel cloth. To protect your windshield, please use Novus #2 to remove minor scratches, or use a polish like Memphis Shades Shinola which is specially designed for plastic windshields; glass cleansing agents will cause severe damage to your windshield and will void your warranty.

Never use any glass products, petroleum based chemicals, or cleaning agents with ammonia, bleach or any harsh chemicals. This includes Rain-X, brake fluid, acetone, and gasoline.

MEM-9858

PARTS LIST

H/W VICTORY SPORTSHIELD HARDWARE KIT

 

 

PART #

DESCRIPTION

QTY.

M858

MOUNTING INSTRUCTIONS/PARTS LIST

1

M302

¼” – 20 X ½” SS SOCKET HEAD CAP SCREW

4

M505

BUTTON NUT

4

M504

SOCKET SHOULDER WASHER

4

M543

SANTOPRENE GROMMET

4

M1027

LEFT MOUNTING PLATE - WIDE

1

M1028

RIGHT MOUNTING PLATE - WIDE

1

 

 

FOR MISSING OR REPLACEMENT PARTS OR WARRANTY

INFORMATION CONTACT

 

 

 

Memphis Shades

PO BOX 24

COLLIERVILLE, TN 38017

(901)-853-0293

 

 

VISIT US ON THE WEB AT

www.memphisshades.com

 

 

CUSTOMER SERVICE

 CUSTOMERSERVICE@MEMPHISSHADES.COM