MEM 9874
SPORTSHIELD
MOUNTING KIT,
INSTRUCTIONS /
PARTS LIST
1. Install the mounting plates onto the windshield using the pre-assembled bolts on the mounting plates. The rubber grommet should be inserted through the holes in the windshield so that the flat round washer part of the grommet lays flat on each side of the windshield. On each plate, get both started before you tighten either. (see Figure 1.1 & 1.2)
Note: *(Wide)
– Tabs point in towards each other.
2. Loosen the four mounting bolts that are to hold the mounting plates to the fork clamps, and slide the mounting plates onto the fork clamps. (see Figure 3)
3. Adjust the height, angle, and alignment of the shield. Carefully check gas tank clearance, and tighten all mounting bolts.
WARNING: This is a quick disconnect kit. Always tighten down all mounting bolts after removing or installing the windshield every time.


Fig. 1.1 Left side plate Fig.1.2 Right side plate Fig. 3 Mounting plate
To clean your windshield,
use only warm water and a mild non-abrasive, dishwashing liquid. Use a soft
cloth, such as a T-shirt or flannel cloth. To protect your windshield, please
use Novus #2 to remove minor scratches, or use a polish like Memphis
Shades Shinola which is specially designed for plastic
windshields; glass cleansing agents will cause severe damage to
your windshield and will void your warranty.
Never use
any glass products, petroleum based chemicals, or cleaning agents with ammonia,
bleach or any harsh chemicals. This includes Rain-X, brake fluid, acetone, and
gasoline.
![]()
![]()
![]()
MEM-9874 MOUNTING KIT
|
PART # |
DESCRIPTION |
QTY. |
|
M874 |
MOUNTING INSTRUCTIONS/PARTS LIST |
1 |
|
M1009 |
LEFT MEANSTREAK MOUNTING PLATE |
1 |
|
M1010 |
RIGHT MEANSTREAK MOUNTING PLATE |
1 |
|
M302 |
¼” – 20 X ½” SS SOCKET HEAD CAP SCREW |
4 |
|
M504 |
SOCKET SHOULDER WASHER |
4 |
|
M505 |
BUTTON NUT |
4 |
|
M543 |
SANTOPRENE GROMMET |
4 |
INFORMATION CONTACT:
(901) 853-0293
customerservice@memphisshades.com