MEM9875
SPORTSHIELD MOUNTING KIT
YAMAHA ROADSTAR WARRIOR
1. Install the mounting plates
onto the windshield using the pre-assembled bolts on the mounting plates. The
rubber grommet should be inserted through the holes in the windshield so the
flat round washer part of the grommet lays flat on each side of the windshield.
On each plate, get both tabs started before you tighten them. (see Figure 1.1 & 1.2)
Note: *(Wide)
– Tabs point in towards each other.
2. Loosen the four bolts that
are to hold the windshield to the fork clamps, and slide the mounting plates
onto
the forks. (See
Figure 2)
3. Adjust the height, angle,
and alignment of the shield and tighten down the bolts that hold the windshield
to the plates, then the bolts that
hold the plates to the fork clamps, then the clamps themselves.
WARNING: This is a quick disconnect kit. Always
tighten down all mounting bolts after removing or installing the windshield, every time.
To clean your windshield,
use only warm water and a mild non-abrasive, dishwashing liquid. Use a soft
cloth, such as a T-shirt or flannel cloth. To protect your windshield, please
use Novus #2 to remove minor scratches,
or use a polish like Memphis Shades Shinola
which is specially designed for plastic windshields; glass cleansing agents
will cause severe damage to your windshield and will void
your warranty.
Never use
any glass products, petroleum based chemicals, or cleaning agents with ammonia,
bleach or any harsh chemicals. This includes Rain-X, brake fluid, acetone, and
gasoline.
MEM-9875 MOUNTING KIT
YAMAHA ROADSTAR WARRIOR SPORTSHIELD
|
PART # |
DESCRIPTION |
QTY. |
|
M875 |
MOUNTING INSTRUCTIONS/PARTS LIST |
1 |
|
M1013 |
LEFT ROADSTAR WARRIOR MOUNTING PLATE |
1 |
|
M1014 |
RIGHT ROADSTAR WARRIOR MOUNTING PLATE |
1 |
|
M302 |
¼” – 20 X ½” SS SOCKET HEAD CAP SCREW |
4 |
|
M504 |
SOCKET SHOULDER WASHER |
4 |
|
M505 |
BUTTON NUT |
4 |
|
M543 |
SANTOPRENE
GROMMET |
4 |
INFORMATION CONTACT:
(901) 853-0293
customerservice@memphisshades.com