MEM-9879

HONDA VTX 1300 C1 CUSTOM 2004 SPORTSHIELD

MOUNTING PLATES INSTRUCTIONS

 

TOOLS REQUIRED:  3/16” Allen Wrench                                      

 

ALWAYS COVER THE FRONT FENDER AND GAS TANK TO PREVENT ANY POSSIBLE DAMAGE

 

1.    Install the mounting plates on the windshield using the bolts that are pre-assembled on the mounting plates. The rubber grommets should be inserted through the holes in the windshield so that the flat round part of the grommet lays flat on each side of the windshield. On each plate, get both tabs started before you tighten them. (See Figure 1.1 & 1.2)                                                                                                                                                                              

 

                        Note:     *(Wide) - Tabs point towards each other when installed correctly.

                                         

2.   Loosen the four bolts that are to hold the mounting plates to the fork clamps and remove the already installed Memphis Fats or Slims.  Slide the new sportshield hardware onto the fork clamps. (See figure 2)

 

 

3.       Adjust the height, angle, and alignment of the shield. Carefully check gas tank clearance, and tighten all mounting bolts.

 

4.    Place the non-used windshield in a safe storage area. Preferably in a Memphis Shades windshield storage bag.

Storage bag for Fats/Slims part #MEM0980, Storage bag for Sportshields part #MEM0985.

 

 

                   WARNING:  This is a quick disconnect kit.  Always tighten down all mounting bolts after removing

                   or installing the windshield every time                                                               

                                                                                               

 Fig. 1.1   Left side plate            Fig. 1.2 Right side plate                  Fig.2 Shows mounting of plates                                                                                                                                         

  

 

Care and Cleaning

 

Never use any Petroleum based chemicals, or cleaning agents with ammonia.

To clean your windshield, use only warm water and a mild, non-abrasive, dishwashing liquid. Use a soft cloth such as a

Cotton T-shirt or flannel cloth.  To protect your windshield use NOVUS #2 to remove minor scratches, or Memphis Shades           Shinola* polish specially designed for plastic, glass cleansing agents will cause severe damage to your windshield, never

MEM-9879 MOUNTING KIT

HONDA VTX 1300 C1 CUSTOM 2004 SPORTSHIELD

 

PART #

DESCRIPTION

QTY.

 

M879

Mounting Instructions/Parts List

1

M1005

Left Mounting Plate

1

M1006

Right Mounting Plate

1

M504

Socket Shoulder Washer

4

M505

Button Nut

4

M543

Santoprene Grommet

4

M302

¼”-20 x ½” SS Socket Head Cap Screw

4

 

 

 

FOR MISSING OR REPLACEMENT PARTS OR WARRANTY

INFORMATION CONTACT:

 

 

Memphis Shades

 P.O. Box 24

Collierville, TN  38017

(901) 853-0293

 

 

VISIT US ON THE WEB AT

www.memphisshades.com                                                                                 

 

 

 

CUSTOMER SERVICE

customerservice@memphisshades.com