MEM-9884

INDEPENDENT LOWERS HARDWARE KIT FOR EXPOSED

FORKS 35-43MM

 

             TOOLS REQUIRED: 3/16” Allen wrench (provided)

 

1.                   Cover the front fender with a towel, in case you drop something.

 

2.                  Attach the lowers plastic to the lowers mounting plates using the pre-assembled  bolts and button nuts. Install the components in the order shown in Figure 1.

 

Note: The neoprene washer has been replaced by four santoprene grommets. The rubber grommets should be inserted through the holes in the windshield so that the flat round part of the grommet lays flat on each side of the windshield.

 

3.                  The mounting plate tabs should point away from each other when installed correctly. (see Figure 2)

 

Note: The mounting plates can be mounted pointing up, for those applications where the windshield is too short to reach them other wise

 

4.                  Loosely install the two fork clamps onto the forks. Attach the lowers mounting plates to the fork clamps. Adjust height, angle and position of clamps and then tighten them.(see Figure 3.1 & 3.2)

               Fig. 1   Order of assembly                              Fig.2  Position of plate tabs

                                   

 

                               Fig. 3.1         Plates pointing up        Fig. 3.2          Plates pointing down                       

                                             

 

CARE AND CLEANING

To clean your windshield, wash it with warm water and a mild, non-abrasive, dishwashing liquid. Use a soft cloth such as a T-shirt or flannel cloth.

 

To protect your windshield, use NOVUS #2 to remove minor scratches, or use Memphis Shades Shinola polish specially designed for plastic. NEVER use glass cleansing agents, they may cause severe damage to your windshield.

MEM9884 MOUNTING KIT

INDEPENDENT LOWERS HARDWARE KIT FOR

EXPOSED FORKS 35-43MM

 

 

PART #

DESCRIPTION

QTY.

M884

INSTRUCTION SHEET /PARTS LIST

1

S1076

LOWERS MOUNTING BRACKET - LEFT

1

S1077

LOWERS MOUNTING BRACKET - RIGHT

1

M501

BEVELED SOCKET WASHER

4

M521

SMALL OUTER ADJUSTABLE CLAMP

2

M520

SMALL INNER ADJUSTABLE CLAMP

2

M302

¼”-20 x ½” SS SHCS

6

M301

¼” –20 x 3/8” SS SHCS

2

M504

SOCKET SHOULDER WASHER

4

M543

SANTOPRENE GROMMET

4

M310

3/16” SHORT ARM ALLEN WRENCH

1

M505

BUTTON NUT

4

 

 

FOR MISSING OR REPLACEMENT PARTS OR WARRANTY INFORMATION CONTACT:

 

Memphis Shades

P.O. Box 24

Collierville, TN 38017

(901) 853-0293

 

VISIT US ON THE WEB AT

www.memphisshades.com

 

 

 

CUSTOMER SERVICE

customerservice@memphisshades.com