MEM-9888

LOW PROFILE INDEPENDENT LOWERS HARDWARE KIT FOR EXPOSED

FORKS 35-43MM

 

TOOLS REQUIRED: 3/16” Allen wrench (provided)

 

1.                  Cover the front fender with a towel, in case you drop something.

 

            Note: The neoprene washer has been replaced by four Santoprene grommets. The rubber grommets should be inserted through the holes in the windshield so that the flat round part of the grommet lays flat on each side of the windshield.

 

 

2.                  Attach the lowers plastic to the lowers mounting plates using the pre-assembled  bolts and button nuts. Install the components in the order shown in Figure 1.

 

3.                  The mounting plate tabs should point away from each other when installed correctly. (see Figure 2)

 

Note: The mounting plates can be mounted pointing up, for those applications where the windshield is too short to reach them other wise

 

4.                  Loosely install the two fork clamps onto the forks. MAKE SURE THE LOWERS WILL CLEAR ALL FENDERS, RADIATORS, OIL COOLERS, ETC. WHEN INSTALLED. Attach the lowers mounting plates to the fork clamps. Adjust height, angle and position of  the clamps and then tighten them.

 

                 Fig. 1   Order of assembly                                Fig.2  Position of plate tabs

                                     

 

                  

                            

CARE AND CLEANING

To clean your windshield, wash it with warm water and a mild, non-abrasive, dishwashing liquid. Use a soft cloth such as a T-shirt or flannel cloth.

 

To protect your windshield, use NOVUS #2 to remove minor scratches, or use Memphis Shades Shinola polish specially designed for plastic. NEVER use glass cleansing agents, they may cause severe damage to your windshield.

 

Never use any petroleum-based chemicals, or cleaning agents with ammonia.

 

 

 

 

MEM9888 MOUNTING KIT

 INDEPENDENT LOWERS FOR 35-43MM FORKS

 

 

 

PART #

DESCRIPTION

QTY.

M888

INSTRUCTION SHEET /PARTS LIST

1

S1085

LOWERS MOUNTING BRACKET LEFT SUB-ASSEMBLY

1

S1086

LOWERS MOUNTING BRACKET RIGHT SUB-ASSEMBLY

1

S1074

SMALL ADJ. FORK CLAMP SUB-ASSEMBLY

2

M313

3/16” ALLEN WRENCH HOLDER (CAP)

1

M310

3/16” SHORT ARM ALLEN WRENCH

1

 

 

 

FOR MISSING OR REPLACEMENT PARTS OR WARRANTY

 INFORMATION CONTACT:

 

Memphis Shades

P.O. Box 24

Collierville, TN 38017

(901) 853-0293

 

VISIT US ON THE WEB AT

www.memphisshades.com

 

 

 

CUSTOMER SERVICE

customerservice@memphisshades.com