MEM-9889

INDEPENDENT LOWERS HARDWARE KIT FOR EXPOSED

FORKS 42-50 MM

 

TOOLS REQUIRED: 3/16” Allen wrench (provided)

 

1.                   Cover the front fender with a towel, in case you drop something.

 

2.                  Attach the lowers plastic to the lowers mounting plates using the pre-assembled bolts and button nuts. Install the components in the order shown in. (see Figure 1)

 

NOTE: The neoprene washers have been replaced by FOUR Santoprene Grommets. The rubber grommet should be inserted through the holes in the windshield so that the flat part of the grommet lays flat on each side of the windshield.

 

 

3.                  The mounting plate tabs should point away from each other when installed correctly. (see Figure 2)

 

Note: The mounting plates can be mounted pointing up, for those applications where the windshield is too short to reach them other wise

 

4.                  Loosely install the two fork clamps onto the forks. Attach the lowers mounting plates to the fork clamps. Adjust height, angle and position of clamps and then tighten them.(see Figure 3.1 & 3.2)

 

                                                                      Fig. 1   Order of assembly                                             Fig.2  Position of plate tabs

        

 

Fig. 3.1 Plates pointing up        Fig. 3.2 Plates pointing down

      

 

CARE AND CLEANING

To clean your windshield, wash it with warm water and a mild, non-abrasive, dishwashing liquid. Use a soft cloth such as a T-shirt or flannel cloth.

 

To protect your windshield, use NOVUS #2 to remove minor scratches, or use Memphis Shades Shinola polish specially designed for plastic. NEVER use glass cleansing agents, they may cause severe damage to your windshield.

 

Never use any petroleum-based chemicals, or cleaning agents with ammonia.

This includes Rain-X, brake fluid, acetone and gasoline.

MEM9889 MOUNTING KIT

INDEPENDENT LOWERS FOR EXPOSED FORKS 42-50MM

 

 

M889

Instructions/Parts List

1

M501

Beveled Socket Washer

2

M301

¼-20 x 3/8” SS SHCS

2

M577

Medium Inner Adj. Fork Clamp Half

2

M578

Medium Outer Adj. Fork Clamp Half

2

M306

¼- 20 x 5/8 SS SHCS

2

M302

¼-20 x ½ SS SHCS

4

M543

Santoprene Grommet

4

M504

Socket Shoulder Washer

4

M505

Button Nut

4

M719

Left Inner Remote Lower Bracket

1

M720

Left Outer Remote Lower Bracket

1

M721

Right Inner Remote Lower Bracket

1

M722

Right Outer Remote Lower Bracket

1

M310

3/16” Short Arm Allen Wrench

1

M313

3/16” Allen Wrench Holder

1

 

 

                                          

                               FOR MISSING OR REPLACEMENT PARTS OR WARRANTY

INFORMATION CONTACT:

 

Memphis Shades

P.O. BOX 24

COLLIERVILLE, TN 38017

(901) 853-0293

 

VISIT US ON THE WEB AT

www.memphisshades.com

 

CUSTOMER SERVICE

customerservice@memphisshades.com