MEM-9892

STANDARD INDEPENDENT LOWERS HARDWARE KIT FOR

COVERED FORKS

 

TOOLS REQUIRED: 3/16” Allen wrench (provided)

 

1.                   Cover the front fender with a towel, in case you drop something.

 

2.                  Attach the lowers plastic to the lowers mounting plates using the pre-assembled  bolts and button nuts. Install the components in the order shown in Figure 1.

 

Note:  The neoprene washer has been replaced by four santoprene grommets. The rubber grommets should be inserted through the holes in the windshield so that the flat round part of the grommet lays flat on each side of the windshield.

 

3.                  The mounting plate tabs should point away from each other when installed correctly. (see Figure 2)

 

Note: The mounting plates can be mounted pointing up, for those applications where the windshield is too short to reach them other wise

 

4.                  Apply the adhesive tape provided to the inside of the clamps to avoid damaging the finish as some manufacturers use lighter material than others for the fork covers.  Trim to proper fit.  Loosely install the two fork clamps onto the fork covers.  MAKE SURE THE LOWERS WILL CLEAR ALL FENDERS, RADIATORS, OIL COOLERS AND TURNSIGNALS WHEN INSTALLED. Attach the lowers mounting plates to the fork clamps. Adjust height, angle and position of the clamps and then tighten them.

 

           Fig. 1   Order of assembly                 Fig.2 Position of plate tabs

                                            

 

                  

                           

 

CARE AND CLEANING

To clean your windshield, wash it with warm water and a mild, non-abrasive, dishwashing liquid. Use a soft cloth such as a T-shirt or flannel cloth.

 

To protect your windshield, use NOVUS #2 to remove minor scratches, or use Memphis Shades Shinola polish specially designed for plastic. NEVER use glass cleansing agents, they may cause severe damage to your windshield.

 

Never use any petroleum-based chemicals, or cleaning agents with ammonia.

 

 

 

MEM9892 MOUNTING KIT

 STANDARD INDEPENDENT LOWERS FOR COVERED FORKS

 

 

 

PART #

DESCRIPTION

QTY.

M892

INSTRUCTION SHEET /PARTS LIST

1

S1076

LOWERS MOUNTING BRACKET LEFT SUB-ASSEMBLY

1

S1077

LOWERS MOUNTING BRACKET RIGHT SUB-ASSEMBLY

1

S1107

EXTRA-LARGE ADJ. FORK CLAMP FOR COV.FORKS

2

M375

P/S ADHESIVE TAPE

2

M313

3/16” ALLEN WRENCH HOLDER (CAP)

1

M310

3/16” SHORT ARM ALLEN WRENCH

1

 

 

 

FOR MISSING OR REPLACEMENT PARTS OR WARRANTY

 INFORMATION CONTACT:

 

Memphis Shades

P.O. Box 24

Collierville, TN 38017

(901) 853-0293

 

VISIT US ON THE WEB AT

www.memphisshades.com

 

 

 

CUSTOMER SERVICE

customerservice@memphisshades.com