MEM-9894

STANDARD INDEPENDENT LOWERS FOR SPRINGER FORKS

INSTRUCTIIONS

 

TOOLS REQUIRED: 3/16” Allen wrench (provided)

 

1.                  Cover the front fender with a towel, in case you drop something.

 

2.          Attach the lowers plastic to the lowers mounting plates using the pre-assembled  bolts and button nuts. Install the components in the order shown in Figure 1.

 

 Note:  The neoprene washer has been replaced by FOUR santoprene grommets. The rubber grommets should be inserted through the holes in the windshield so that the flat round part of the grommet lays flat on each side of the windshield.

 

 

3.         The mounting plate tabs should point away from each other when installed correctly. (see Figure 2)

 

 

            4.         Install the two clamps onto the fork legs just above the yoke, and attach the lowers mounting plates        

                          to the fork clamps.

 

                        Note: the mounting plates can be mounted pointing up, for applications where the windshield is too

                          short to reach them otherwise.

 

            5.         Make sure the lowers don’t interfere with anything when the forks are turned all the way in either

                        direction.

 

 

           Fig. 1   Order of assembly                 Fig.2 Position of plate tabs

                                        

 

                   

                           

 

 

     CARE AND CLEANING

To clean your windshield, wash it with warm water and a mild, non-abrasive, dishwashing liquid. Use a soft cloth such as a T-shirt or flannel cloth.

 

To protect your windshield, use NOVUS #2 to remove minor scratches, or use Memphis Shades Shinola polish specially designed for plastic. NEVER use glass cleansing agents, they may cause severe damage to your windshield.

 

Never use any petroleum-based chemicals, or cleaning agents with ammonia.

 

MEM9894

MOUNTING KIT

 STANDARD INDEPENDENT LOWERS FOR SPRINGER FORKS

 

 

 

PART #

DESCRIPTION

QTY.

M894

INSTRUCTION SHEET /PARTS LIST

1

S1076

LOWERS MOUNTING BRACKET LEFT SUB-ASSEMBLY

1

S1077

LOWERS MOUNTING BRACKET RIGHT SUB-ASSEMBLY

1

S1146

 ADJUSTABLE. FORK CLAMP FOR SPRINGER FORKS

2

M313

3/16” ALLEN WRENCH HOLDER (CAP)

1

M310

3/16” SHORT ARM ALLEN WRENCH

1

 

 

 

FOR MISSING OR REPLACEMENT PARTS OR WARRANTY

 INFORMATION CONTACT:

 

Memphis Shades

P.O. Box 24

Collierville, TN 38017

(901) 853-0293

 

VISIT US ON THE WEB AT

www.memphisshades.com

 

 

 

CUSTOMER SERVICE

customerservice@memphisshades.com