MEM-9908

MEMPHIS SHADES FATS/SLIMS MOUNTING KIT *WIDE

MOUNTING INSTRUCTIONS/PARTS LIST

 

TOOLS REQUIRED:

 

3/16” Allen Wrench

7/16” or 11mm Wrench

 

 

1.       Loosely install the two mounting plates on the windshield, using the bottom bolt and the third bolt up.  Leave the nylon washers off.  The small tab goes at the bottom, big one at the top. (See figure 1)

 

Install Note:                     *(Wide) -Tabs point away from each other when installed correctly

                               

2.   Loosely install the four fork clamps on the forks, approximately two inches apart. (See figure 2)

 

3.      Loosen the four bolts that are to hold the windshield to the fork clamps, and slide the mounting plates onto the fork clamps. (See figure 3)

 

4.      Adjust the height, angle, and alignment of the shield and tighten down the bolts that hold the windshield to the plates, then the bolts that hold the plates to the fork clamps, then the clamps themselves.

 

5.    WARNING:  This is a quick disconnect kit.  Always tighten down all mounting bolts after removing

       or installing the windshield every time                                     

                                                                                                                     FRONT OF BIKE

 


                       

FIGURE 1                                             FIGURE 2                                                FIGURE 3

 

 

Care and Cleaning Instructions

 

To clean your windshield, use only warm water and a mild non-abrasive, dishwashing liquid. Use a soft cloth, such as a T-shirt or flannel cloth. To protect your windshield, please use Novus #2 to remove minor scratches, or use a polish like Memphis Shades Shinola which is specially designed for plastic windshields; glass cleansing agents will cause severe damage to your windshield and will void your warranty.

Never use any glass products, petroleum based chemicals, or cleaning agents with ammonia, bleach or any harsh chemicals. This includes Rain-X, brake fluid, acetone, and gasoline

 

MEM 9908 MOUNTING KIT

MEMPHIS FATS/SLIMS *WIDE

 

 

PART #

 

DESCRIPTION

QTY.

 

M908

Mounting Instructions/Parts List

1

M596

Left Mounting Plate Fats/Slims

1

M597

Right Mounting Plate Fats/Slims

1

M302

1/4”-20 x 1/2” SS Socket Head Cap Screw

4

M301

         1/4”-20 x 3/8” SS Socket Head Cap Screw

4

M501

 Beveled Socket Washer

4

M561

1/4” x 3/4” Beveled Spacer Washer

4

M520

Inner Adj. Fork Clamp Half

4

M521

Outer Adj. Fork Clamp Half

4

M306

1/4” – 20 x 5/8” SS Socket Head Cap Screw

4

M314

3/16” T-Handle Allen Wrench

1

M310

3/16” Short Arm Allen Wrench

1

M337

3/16” T-Handle Wrench Cover

1

M313

3/16” Allen Wrench Cover

1

 

 

FOR MISSING OR REPLACEMENT PARTS OR WARRANTY

INFORMATION CONTACT:

 

 

Memphis Shades

P.O. BOX 24

COLLIERVILLE, TN 38017

(901)-853-0293

 

 

VISIT US ON THE WEB AT

www.memphisshades.com

 

 

CUSTOMER SERVICE

customerservice@memphisshades.com