MEM 9918

MEMPHIS FATS / SLIMS MOUNTING KIT

99 1100 V-STAR

INSTRUCTIONS / PARTS LIST

 

TOOLS REQUIRED:  3/16” Allen wrench (provided)

                                       7/16” (or 11mm) wrench

 

1.  Loosely install the two mounting plates on the windshield, using the bottom and third bolt up, leaving off the nylon washers. The small tab goes at the bottom, large tab at the top.   (See Figure 1)

 

NOTE: Tabs should point in towards the center of the shield.

 

2.  Loosely install the four fork clamps on the forks, approximately two inches apart.

     (See Figure 2)

 

3.  Loosen the four bolts that are to hold the windshield to the fork clamps, and slide the mounting plates onto the fork clamps. (See Figure 3)

 

 4.  Adjust the height, angle and alignment of the shield and tighten down the bolts that hold the windshield to the    plates, then the bolts that hold the plates to the fork clamps, then the clamps themselves.

 

       WARNING:         This is a quick disconnect kit. Be sure to tighten down all mounting bolts after removal or installation, every time.

 

              Fig. 1 Mounting plate to w/s                 Fig. 2 Fork clamps              Fig. 3 plate to forks

                                                 

 

 

Care and Cleaning Instructions

 

To clean your windshield, use only warm water and a mild non-abrasive, dishwashing liquid. Use a soft cloth, such as a T-shirt or flannel cloth. To protect your windshield, please use Novus #2 to remove minor scratches, or use a polish like Memphis Shades Shinola which is specially designed for plastic windshields; glass cleansing agents will cause severe damage to your windshield and will void your warranty.

Never use any glass products, petroleum based chemicals, or cleaning agents with ammonia, bleach or any harsh chemicals. This includes Rain-X, brake fluid, acetone, and gasoline.

 

 

 

 

 

MEM9918 MOUNTING KIT

MEMPHIS FATS/SLIMS 1999 V-STAR 650/1100 CUSTOM

 

 

 

PART #

 

DESCRIPTION

QTY.

 

M918

Mounting Instructions/Parts List

1

M739

Left Mounting Plate Fats/Slims

1

M740

Right Mounting Plate Fats/Slims

1

M302

1/4”- 20 x 1/2” SS Socket Head Cap Screw

4

M501

 Beveled Socket Washer

4

M561

1/4” x 3/4” Beveled Spacer Washer

4

M306

1/4”- 20 x 5/8” SS Socket Head Cap Screw

4

M520

Inner Adjustable Fork Clamp Half

4

M521

Outer Adjustable Fork Clamp Half

4

M314

3/16” T-Handle Allen Wrench

1

M310

3/16” Short Arm Allen Wrench

1

M337

3/16” T-Handle Wrench Cover

1

M313

3/16” Allen Wrench Cover

1

 

 

 

FOR MISSING OR REPLACEMENT PARTS OR WARRANTY

INFORMATION CONTACT:

 

 

Memphis Shades

 P.O. Box 24

Collierville, TN  38017

(901) 853-0293

 

VISIT US ON THE WEB AT:

www.memphisshades.com

 

CUSTOMER SERVICE

customerservice@memphisshades.com