TOOLS REQUIRED

(1) Towel

(1) 6mm Allen wrench (provided)

(1) 8mm wrench

(1) 3/16” Allen wrench (provided)

(1) 7/16” or 11mm wrench

Always cover the front fender and gas tank with a towel to avoid possible damage.

1. Using the 6mm Allen wrench provided, remove the two, original, upper triple tree pinch bolts. Replace them with the L-shaped upper bracket assemblies. New longer bolts with spacers are provided. (See Figure 1)

2. Using a 8mm wrench, remove the two bolts that hold the turn signal bar in place, slip the lower bracket from the kit behind the turn signal bar and re-install the bolts. The ears on the lower mounting bracket should be turned up and toward the forks. (See Figure 2)

3. Loosely attach the windshield to the windshield mounting plates using the bottom and third bolt up on each side. Leave the nylon washers off. The mounting tabs should be pointing away from the headlight when installed correctly. (See Figure 3)

4. Loosen the mounting bolts on the upper and lower brackets that hold the windshield plates. Slip the windshield plates onto the mounting brackets, starting the bottom of the windshield mounting plate first.

WARNING: NEVER RIDE WITH ANY PART OF THE MOUNTING HARDWARE MISSING OR LOOSE

Fig. 1 - upper bracket mounted Fig. 2 -lower bracket mounted Fig. 3 -left side w/s mounting plate

Care and Cleaning Instructions

To clean your windshield, use only warm water and a mild non-abrasive, dishwashing liquid. Use a soft cloth, such as a T-shirt or flannel cloth. To protect your windshield, please use Novus #2 to remove minor scratches, or use a polish like Memphis Shades Shinola which is specially designed for plastic windshields; glass cleansing agents will cause severe damage to your windshield and will void your warranty.

Never use any glass products, petroleum based chemicals, or cleaning agents with ammonia, bleach or any harsh

chemicals. This includes Rain-X, Brake Fluid, Acetone, and Gasoline.

MEM-9920 MOUNTING KIT

MEMHIS FATS/SLIM FOR VT 1100C2 SHADOW SABRE

PART #	DESCRIPTION	QTY.
M920	MOUNTING INSTRUCTIONS/PART LIST	1
M764	HONDA SABRE 1100 UPPER BRACKET	2
M320	8mm X 45mm SS SOCKET HEAD CAP SCREW	2
M321	5/16” SS WASHER	2
M591	PINCH BOLT SPACER	2
M505	BUTTON NUT	4
M586	RECESSED SPACER WASHER	4
M501	BEVELED SOCKET WASHER	4
M302	1/4”- 20 X 1/2” SOCKET HEAD CAP SCREW	4
M762	HONDA SABRE 1100 VERTICAL PLATE–LEFT	1
M763	HONDA SABRE 1100 VERTICAL PLATE–RIGHT	1
M761	HONDA SABRE 1100 LOWER BRACKET	1
M310	3/16” SHORT ARM ALLEN WRENCH	1
M313	3/16" ALLEN WRENCH COVER	1
M311	6mm SHORT ARM ALLEN WRENCH	1

FOR MISSING OR REPLACEMENT PARTS OR WARRANTY

INFORMATION CONTACT:

Memphis Shades

P.O. BOX 24

COLLIERVILLE, TN 38017

(901) 853-0293

VISIT US ON THE WEB AT:

www.memphisshades.com

CUSTOMER SERVICE

customerservice@memphisshades.com