TOOLS REQUIRED:

(1) Towels

(1) 6mm Allen wrench (provided)

(1) ½” wrench

(1) 3/16” Allen wrench (provided)

(1) 7/16” or 11mm wrench

Always cover the front fender and gas tank with a towel to avoid possible damage.

1. Using a 1/2” wrench, remove the two original upper passing lamp bolts located on the sides of the forks, also temporarily remove the steel spacers behind the passing lamp frame. Replace the bolts with the new longer upper mount assemblies (use the 1-1/2” long bolt assemblies). Reinstall the original steel spacers behind the light bar bracket. (See note) Leave the assemblies loose to enable the windshield to slip into place later.

2. Using the 6mm Allen wrench provided, loosely install the two lower mounting bolts (use the ½” long bolt assemblies) directly underneath the new upper bolt assemblies, currently there are no bolts in these holes.

3. Loosely attach the windshield to the windshield mounting plates using the bottom and third bolt up on each side. Leave the nylon washers off. The mounting tabs should be pointing in towards the headlight when installed correctly.

4. With the mounting bolts loose, slip the windshield plates onto the mounting brackets, adjust the angle and height to the desirable location and tighten all mounting hardware.

5. To remove and install the windshield, loosen all four of the mounting points and slip the windshield from it’s place, make sure to always tighten the bolts when the shield is removed.

6. Carefully check gas tank clearance, as some models might have had aftermarket gas tanks put on. Turn the

steering stop to stop and make sure the hardware does not strike the fuel tank.

WARNING: NEVER RIDE WITH ANY PART OF THE MOUNTING HARWARE MISSING OR LOOSE

Care and Cleaning Instructions

To clean your windshield, use only warm water and a mild non-abrasive, dishwashing liquid. Use a soft cloth, such as a T-shirt or flannel cloth. To protect your windshield, please use Novus #2 to remove minor scratches, or use a polish like Memphis Shades Shinola which is specially designed for plastic windshields; glass cleansing agents will cause severe damage to your windshield and will void your warranty.

Never use any glass products, petroleum based chemicals, or cleaning agents with ammonia, bleach or any harsh chemicals. This includes Rain-X, brake fluid, acetone, and gasoline.

MEM-9925 MOUNTING KIT

MEMPHIS FATS/SLIMS H-D HERITAGE SOFTAIL AND H-D FAT BOY WITH PASSING LAMPS

PART #	DESCRIPTION	QTY.
M925	Mounting Instructions/Parts List	1
M770	Left Mounting Plate Fats/Slims	1
M771	Right Mounting Plate Fats/Slims	1
M361	5/16”-24x 1-1/2” SS Socket Head Cap Screw	2
M350	5/16”-24x 5/8” SS Socket Head Cap Screw	2
M567	7/8” Beveled Socket Washer	4
M569	7/8” Shoulder Spacer (Upper)	4
M310	3/16” Short Arm Allen Wrench	1
M311	6MM Short Arm Allen Wrench	1
M313	3/16” Short Arm Allen Wrench Cover	1

FOR MISSING OR REPLACEMENT PARTS OR WARRANTY

INFORMATION CONTACT:

Memphis Shades

P.O. Box 24

Collierville, TN 38017

(901) 853-0293

VISIT US ON THE WEB AT

www.memphisshades.com

CUSTOMER SERVICE