MEM 9936

SPORTSHIELD MOUNTING KIT, H-D V-ROD

INSTRUCTIONS / PARTS LIST

 

TOOLS REQUIRED:  3/16” Allen wrench (provided)

 

1.                  Install the mounting plates onto the windshield using the pre-assembled bolts on the mounting plates. Use neoprene washers on both sides of the windshield. On each plate, get both tabs started before you tighten them. (see Figure 1.1 & 1.2)

 

                Note:    *(Wide)  – Tabs point in towards each other.

 

2.                  Loosely install the four fork clamps 1” down from the upper triple tree and 1-3/4” inches apart.

              (see Figure 2)

 

3.                  Install the Headlight visor.(See separate mounting instruction sheet)

 

4.                  Loosen the four mounting bolts that are to hold the mounting plates to the fork clamps, and slide the mounting plates onto the fork clamps. (see Figure 3)

 

5.                  Adjust the height, angle, and alignment of the shield. Carefully check clearance from steering stop to stop, and tighten all mounting bolts.

 

WARNING:   This is a quick disconnect kit. Always tighten down all mounting bolts after removing or installing the windshield every time.

 

  Fig. 1.1  Left side plate    Fig. 1.2 Right side plate      Fig. 2 fork clamps                              Fig. 3  Plate mounting

1-3/4"                    

 

Care and Cleaning Instructions

 

To clean your windshield, use only warm water and a mild non-abrasive, dishwashing liquid. Use a soft cloth, such as a T-shirt or flannel cloth. To protect your windshield, please use Novus #2 to remove minor scratches, or use a polish like Memphis Shades Shinola which is specially designed for plastic windshields; glass cleansing agents will cause severe damage to your windshield and will void your warranty.

Never use any glass products, petroleum based chemicals, or cleaning agents with ammonia, bleach or any harsh chemicals. This includes Rain-X, brake fluid, acetone, and gasoline.

 

MEM9936 PARTS LIST

V-ROD SPORTSHIELD HARDWARE KIT

 

PART #

DESCRIPTION

QTY.

M936

MOUNTING INSTRUCTIONS/PARTS LIST

1

M301

1/4" - 20 X 3/8" SS SOCKET HEAD CAP SCREW

4

M369

.750” X .250” X .036” SS FLAT WASHER

4

M302

¼” – 20 X ½” SS SOCKET HEAD CAP SCREW

4

M303

1/4" - 20 X 3/4" SS SOCKET HEAD CAP SCREW

4

M313

3/16” SHORT ARM ALLEN WRENCH COVER

1

M314

3/16” T-HANDLE ALLEN WRENCH

1

M337

3/16” T-HANDLE ALLEN WRENCH COVER

1

M310

3/16" SHORT ARM ALLEN WRENCH

1

M523

LARGE INNER ADJ. FORK CLAMP

4

M522

LARGE OUTER ADJ. FORM CLAMP

4

M505

BUTTON NUT

4

M504

SOCKET SHOULDER WASHER

4

M543

SANTOPRENE GROMMET

4

M501

BEVELED SOCKET WASHER

4

M1023

LEFT MOUNTING PLATE - WIDE

1

M1024

RIGHT MOUNTING PLATE - WIDE

1

 

 

FOR MISSING OR REPLACEMENT PARTS OR WARRANTY

INFORMATION CONTACT:

Memphis Shades

P.O. BOX 24

COLLIERVILLE, TN 38017

(901)-853-0293

 

VISIT US ON THE WEB AT

www.memphisshades.com

 

CUSTOMER SERVICE

customerservice@memphisshades.com