MEM 9937

SPORTSHIELD MOUNTING KIT SUZUKI MARAUDER

INSTRUCTIONS / PARTS LIST

TOOLS REQUIRED: 3/16” Allen wrench (provided)

1. Install the mounting plates onto the windshield using the pre-assembled bolts on the mounting plates. Use neoprene washers on both sides of the windshield. On each plate, get both tabs started before you tighten them. (see Figure 1.1 & 1.2) Note: *(Wide) – Tabs point in towards each other.

2. Loosely install the four fork clamps on the forks, approximately 1.75 inches apart. (see Figure 2)

INSTALL NOTE: THE INTERLOCKING PARTS SHOULD BE ON THE FRONT SIDE OF THE FORKS WHEN INSTALLED PROPERLY.

3. Loosen the four mounting bolts that are to hold the mounting plates to the fork clamps, and slide the mounting plates onto the fork clamps. (see Figure 3)

4. Adjust the height, angle, and alignment of the shield. Carefully check gas tank clearance, and tighten all mounting bolts.

5. Make sure to check gas tank clearance and that no parts are rubbing before riding with the windshield.

WARNING: This is a quick disconnect kit. Always tighten down all mounting bolts after removing

or installing the windshield every time.

Fig. 1.1 Left side plate Fig. 1.2 Right side plate Fig. 2 fork clamps Fig. 3 shows mounting of plates

Care and Cleaning Instructions

To clean your windshield, use only warm water and a mild non-abrasive, dishwashing liquid. Use a soft cloth, such as a T-shirt or flannel cloth. To protect your windshield, please use Novus #2 to remove minor scratches, or use a polish like Memphis Shades Shinola which is specially designed for plastic windshields; glass cleansing agents will cause severe damage to your windshield and will void your warranty.

Never use any glass products, petroleum based chemicals, or cleaning agents with ammonia, bleach or any

MEM 9937 MOUNTING KIT

MARAUDER SPORTSHIELD

PART #	DESCRIPTION	QTY.
M937	Mounting Instructions/Parts List	1
M1021	Left Mounting Plate	1
M1022	Right Mounting Plate	1
M522	Large outer adj. Fork clamp half	4
M523	Large inner adj. Fork clamp half	4
M559	1/8” x 3/4” Beveled Spacer Washer	4
M501	Beveled Socket Washer	4
M303	1/4”- 20 x 3/4” SS Socket Head Cap Screw	4
M504	Socket Shoulder Washer	4
M505	Button Nut	4
M543	Santoprene Grommet	4
M302	¼” – 20 x ½” SS Socket Head Cap Screw	8
M310	3/16” Short Arm Allen Wrench	1
M313	3/16” Allen Wrench Cover	1
M314	3/16" T-Handle Allen Wrench	1
M337	3/16" T-Handle Allen Wrench Cover	1

FOR MISSING OR REPLACEMENT PARTS OR WARRANTY

INFORMATION CONTACT:

Memphis Shades

P.O. Box 24

Collierville, TN 38017

(901) 853-0293

VISIT US ON THE WEB AT

www.memphisshades.com

CUSTOMER SERVICE