MEM 9959

SPORTSHIELD MOUNTING KIT, VSTR650/100 CUSTOM

INSTRUCTIONS / PARTS LIST

 

TOOLS REQUIRED:  3/16” Allen wrench (provided)

 

1.                  Install the mounting plates onto the windshield using the pre-assembled bolts on the mounting plates. The rubber grommets should be inserted through the holes in the windshield so the flat round washer part of the grommet lays flat on each side of the windshield. On each plate, get both tabs started before you tighten them. (see Figure 1.1 & 1.2)

 

                                              Note:    *(Wide)      – Tabs point in towards each other.

 

2.                  Loosely install the four fork clamps on the forks, 1-3/4 inches apart. (see Figure 2)

 

3.                  Loosen the four mounting bolts that are to hold the mounting plates to the fork clamps, and slide the mounting plates onto the fork clamps. (see Figure 3)

 

4.                  Adjust the height, angle, and alignment of the shield. Carefully check gas tank clearance, and tighten all mounting bolts.

 

WARNING:   This is a quick disconnect kit. Always tighten down all mounting bolts after removing or installing the windshield every time.

 

1-3/4"Fig. 1.1  Left side plate  Fig. 1.2 Right side plate    Fig. 2 fork clamps                             Fig. 3  shows mounting                                                            

 

 

Care and Cleaning Instructions

 

To clean your windshield, use only warm water and a mild non-abrasive, dishwashing liquid. Use a soft cloth, such as a T-shirt or flannel cloth. To protect your windshield, please use Novus #2 to remove minor scratches, or use a polish like Memphis Shades Shinola which is specially designed for plastic windshields; glass cleansing agents will cause severe damage to your windshield and will void your warranty.

Never use any glass products, petroleum based chemicals, or cleaning agents with ammonia, bleach or any harsh chemicals. This includes Rain-X, brake fluid, acetone, and gasoline.

 

 

MEM-9959 MOUNTING KIT

SPORTSHIELD VSTR650/1100CUSTOM

 

 

PART#

DESCRIPTION

QTY.

M959

MOUNTING INSTRUCTIONS/PART LIST

1

M302

1/4” – 20 X 1/2” SS SOCKET HEAD CAP SCREW

8

M306

1/4” – 20 X 5/8” SS SOCKET HEAD CAP SCREW

4

M520

INNER ADJUSTABLE FORK CLAMP HALF

4

M521

OUTER ADJUSTABLE FORK CLAMP HALF

4

M501

BEVELED SOCKET WASHER

4

M561

¼” X ¾” BEVELED SPACER WASHER

4

M711

SPORTSHIELD MOUNTING PLATE - LEFT, H-D WIDE

1

M712

SPORTSHIELD MOUNTING PLATE  - RIGHT, H-D WIDE

1

M310

3/16” SHORT ARM ALLEN WRENCH

1

M313

3/16” SHORT ARM ALLEN WRENCH COVER

1

M314

3/16” T-HANDLE ALLEN WRENCH

1

M337

3/16” T-HANDLE ALLEN WRENCH COVER

1

M504

SOCKET SHOULDER WASHER

4

M543

SANTOPRENE GROMMETT

4

M505

BUTTON NUT

4

 

 

FOR MISSING OR REPLACEMENT PARTS OR WARRANTY

INFORMATION CONTACT:

 

Memphis Shades

P.O. BOX 24

COLLIERVILLE, TN 38017

(901) 853-0293

 

VISIT US IN THE WEB AT

www.memphisshades.com

 

CUSTOMER SERVICE

customerservice@memphisshades.com